ClayAiken Posted April 19, 2013 Report Posted April 19, 2013 Isnt that a PVL Ignition or something like that? I don't know shit about it but i think i done seen a picture of one before. Quote
bansheefromhell Posted April 19, 2013 Author Report Posted April 19, 2013 I was going to start pulling the engine and tearing everything apart went to take the cover off to pull the flywheel and went wtf? Quote
n2otoofast4u Posted April 19, 2013 Report Posted April 19, 2013 PVL.... You will need a different puller to remove it. Quote
Starwriter Posted April 19, 2013 Report Posted April 19, 2013 Otherwise known as a steering wheel puller or harmonic balancer puller. Quote
bansheefromhell Posted April 19, 2013 Author Report Posted April 19, 2013 Otherwise known as a steering wheel puller or harmonic balancer puller.I thought so, that's good I do have one if those Quote
m671054 Posted April 19, 2013 Report Posted April 19, 2013 Any thought to how your going to time it going together? no key is used on flywheel Quote
bansheefromhell Posted April 19, 2013 Author Report Posted April 19, 2013 Any thought to how your going to time it going together? no key is used on flywheelit still uses a crank key Quote
bansheefromhell Posted April 19, 2013 Author Report Posted April 19, 2013 Any thought to how your going to time it going together? no key is used on flywheelit still uses a crank keywell fuck I thought it did but not seeing one, I will make a mark where it's at Quote
jbooker82 Posted April 19, 2013 Report Posted April 19, 2013 it still uses a crank key Really. I didn't they they did. Maybe they changed and are now using key ways. I know you use to have to find TDC on the motor then set your own ignition timing. Quote
bansheefromhell Posted April 19, 2013 Author Report Posted April 19, 2013 it still uses a crank keyReally. I didn't they they did. Maybe they changed and are now using key ways. I know you use to have to find TDC on the motor then set your own ignition timing.y'all are right it don't damn... Quote
jbooker82 Posted April 19, 2013 Report Posted April 19, 2013 Almost looks like you set the motor to TDC then the line on the rotor lines up with the line on the top piece. You can see in your pic that they are almost lined up now. I don't know if that is how your suppose to do it but it kind of looks like it. Quote
bansheefromhell Posted April 19, 2013 Author Report Posted April 19, 2013 Ha Good luck!O well I guess I could of pulled the cover off and found a Ricky stator lol Quote
wacko2000 Posted April 19, 2013 Report Posted April 19, 2013 Bought a bike a few weeks ago with a PVL, a 3 jaw gear puller from sears will work just fine Joe Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.