what type of flywheel is this?

[bansheefromhell]

[ClayAiken]

Isnt that a PVL Ignition or something like that? I don't know shit about it but i think i done seen a picture of one before. 

[bansheefromhell]

I was going to start pulling the engine and tearing everything apart went to take the cover off to pull the flywheel and went wtf?

[n2otoofast4u]

PVL.... You will need a different puller to remove it.

[Starwriter]

Otherwise known as a steering wheel puller or harmonic balancer puller.

[bansheefromhell]

Otherwise known as a steering wheel puller or harmonic balancer puller.

I thought so, that's good I do have one if those

[m671054]

Any thought to how your going to time it going together? no key is used on flywheel

[bansheefromhell]

Any thought to how your going to time it going together? no key is used on flywheel

it still uses a crank key

[bansheefromhell]

 

Any thought to how your going to time it going together? no key is used on flywheel

it still uses a crank key

well fuck I thought it did but not seeing one, I will make a mark where it's at

[jbooker82]

it still uses a crank key

Really. I didn't they they did. Maybe they changed and are now using key ways.  I know you use to have to find TDC on the motor then set your own ignition timing.

[bansheefromhell]

 

it still uses a crank key

Really. I didn't they they did. Maybe they changed and are now using key ways. I know you use to have to find TDC on the motor then set your own ignition timing.

y'all are right it don't damn...

[jbooker82]

Almost looks like you set the motor to TDC then the line on the rotor lines up with the line on the top piece. You can see in your pic that they are almost lined up now. I don't know if that is how your suppose to do it but it kind of looks like it.

[Finch]

Ha Good luck!

[bansheefromhell]

Ha Good luck!

O well I guess I could of pulled the cover off and found a Ricky stator lol

[wacko2000]

Bought a bike a few weeks ago with a PVL, a 3 jaw gear puller from sears will work just fine

Joe