Banshee wheelie problems

[h20dies]

So i have tried to wheelie my banshee and it lifts up no problem in pretty much every gear if i try hard, but when i lift it up it is EXTREMELY hard to balance and it pulls to the right where if i do wheelie i can't for long because it pulls to the right and i have overtipped it twice because it goes so far it hits my grab bar and it flips to the right. damaging my bike so is this common for the grab bar? What aftermarket grab should i get? (: What should i do?

[Colby]

PRM grab-bar ..  check your right rear tire pressure..  and make sure your axle is not bent ..  and practice!

[locogato11283]

Going one way or the other is a tire pressure issue. They're not the same.

 

I can tell you from experience, the first time you put it on the grab bar really hard in the grass, you're going to be replacing more than just a grab bar.

[Starwriter]

LMAO The grab bar is not a wheelie bar.

 

X2 on checking tire pressure.

[Nightmare]

Sub-frames love that shit:lol:

 

Sent from my SGH-T679 using Tapatalk 2

[Nieskes]

Best way is to come to a dead stop, 1st gear, pull the clutch in, lean back, hold the throttle wide open, then dump the clutch. This should allow you to control the wheelie alot better, an ride it for miles.

[h20dies]

I have the want to ride wheelies I don't ride fast wheelies so when i go down it's not the bad i don't leave 1st gear i'll check all thanks.

[h20dies]

And If i have a wheelie bar..... that would not even allow me to enjoy the full wheelie.. am i right?

[03DMshee]

PRM grab bar is best due to the width...as far as the wheelies there is more to it then just yanking it up...Banshee is way explosive so you need to be good with the rear brake or your gonna be replacing all sorts of shit...first off get good rear brake pads or you will replace them every three rides...make sure rear brake is bled well and is more on the touchy side...what do you want out of the bike? Are you trying to just wheelie it all the time? Or you want all around bike? Cause you can get larger sprocket in rear to assist...also get a top end pipe that way the pipe doesn't hit low...so you can roll a nice slow wheelie without ever getting into powerband...sucks for your plugs but what do you wanna do? There's a million variables to wheeling a banshee...you Fortran decide what you want...I like to pull front end in first and shift to third that way you can bog the motor slowing more control...have fun and wear a helmet!

[Nieskes]

 

And If i have a wheelie bar..... that would not even allow me to enjoy the full wheelie.. am i right?

Wheelie bars are for pussies!

[Uf21]

I hear that advancing timing is good for wheelies? is this true?

 

Do you guys always dump the clutch to get it up?

[fastforworddad]

Do you guys always dump the clutch to get it up?

 

No, I usually let the wife rub on it a bit, that usually does it.

[Uf21]

No, I usually let the wife rub on it a bit, that usually does it.

 

Let her also rub my one.

[Uf21]

Let her also rub my one.

[Nieskes]

I hear that advancing timing is good for wheelies? is this true?

 

Do you guys always dump the clutch to get it up?

ya dump the clutch, 10 degrees works the best for wheelies.