Head torque spec for noss head

[turbowrenchhead]

Should I run the stock torque spec or something different for a noss head?

[SAVAGE420]

I go all hand tight, 10,15 then 22 in a x-cross pattern. Light coat of grease on all o-rings first, will make install 10x easier.

[badassbanshee479]

I step tq it as mentioned above to 20-22 ft lbs and I tq it in the same pattern as the stock head... If you have a stock head laying around the pattern is written on it... It's numbered 1-10

[trickedcarbine]

Another nice assembly tip: leave the jugs just loose and step torque the head then snug the jugs down