codynewman13 Posted July 8, 2011 Report Posted July 8, 2011 i just rebuilt the top end on my banshee i put it all together the right way which i have done before, but when i went to start it it never started so i gave it a push start and it fired up but was pouring smoke and oil from the right cylinder and not firing on the left cylinder? i changed plugs switched carbs over switched reeds over swithcehd plug wires over and it always does the same thing i dont know what the problem is? it cannot kick start on its own either because of this do you guys have any idea what it might be? i really hope its nothing major Quote
BrockMoto Posted July 8, 2011 Report Posted July 8, 2011 Why were you rebuilding? Leak down? Compression test... Quote
codynewman13 Posted July 9, 2011 Author Report Posted July 9, 2011 Why were you rebuilding? Leak down? Compression test... i rebuilt it because it busted a ring before, will a bad crank seal affect being able to start it and its compression? Quote
majorcr3 Posted July 9, 2011 Report Posted July 9, 2011 Did you put one of the pistons on backwards? Iv done it and seems like it did the same thing. Quote
Jereme6655 Posted July 9, 2011 Report Posted July 9, 2011 did you install the rings correctly around the pins on both the carbs correctly? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.