Stupid question

[papasmurf]

The banshee has an air screw on both carbs correct? If so how in the hell do I adjust the carb where the screw is in the middle of both carbs? The way my banshee is wired there's like 5 wires going through that area and I can't even see the screw.

[shadowbanshee]

i would say that you still have TORS, get new carbs or get rid of them, never had them but ive heard nothing but bad stuff about them

[06specialedition]

You should still be able to get a shorty flat head screw driver in there no problem.

[itscody]

You should still be able to get a shorty flat head screw driver in there no problem.

 

I had to remove mine to adjust screws

[FASTOYS]

We use a long skinny straight blade screw driver.

[AKheathen]

We use a long skinny straight blade screw driver.

x2, i think it was an 8", or 10" when i had stockers....just reach over the left carb to adjust the right...you can see it if you remove the seat. the wires will move

[papasmurf]

x2, i think it was an 8", or 10" when i had stockers....just reach over the left carb to adjust the right...you can see it if you remove the seat. the wires will move

 

 

Yea i managed to get to the screw it was just a bit of a pain and required an extra long screw driver. Anyway turns out i was running lean, im only about 1 full turn out on the air screws and it runs much better. Bottom end is improved and doesn't bog down at low rpms anymore.

[AKheathen]

remember to tune it to a hot engine, or you could have hot-starting trouble, and/or plug fouling

[2 Stroke Screamer]

x2, i think it was an 8", or 10" when i had stockers....just reach over the left carb to adjust the right...you can see it if you remove the seat. the wires will move

 

x3 long skinny flat blade take your seat off and shine a good torch down between the carbys. If that fails it might be time to get glasses.