cylinder

[smzj4]

Is it ok if the ports on the inside of the cylinders aren't chamfered? Would you run it like that?

Thanks.

[JCMshee]

Get them chamfered because it prevents premature wear on the piston and ring assembly.

[jbooker82]

The sharp lip on the ports will shave the new rings and piston. No way i would run it like that.

[2001blackshee]

Is it ok if the ports on the inside of the cylinders aren't chamfered? Would you run it like that?

Thanks.

 

 

 

I jus broke 1 of my piston into 3 peices bc the cylinders were chamfered... youll be saving time and money getting it done!!!

[smzj4]

Ok well it looks like I'm doing to send it to a site sponsor to get done. I dont know anybody where i live that will do a good job.

[2001blackshee]

Ok well it looks like I'm doing to send it to a site sponsor to get done. I dont know anybody where i live that will do a good job.

 

 

 

I just sent mine to Jeff from FAST... Hes well reputed on this forume.. why i went with him!!!

[bebetekbanshee358]

very simple. 3 dollar fix.. either use a small piece of sandpaper or a small mini file and file the sharp edges make em round.. u dont goota send them out and wait a week or two to do this.. itll take like 20 minutes to do both cyl.... very easy,,,, very noobie

[2001blackshee]

very simple. 3 dollar fix.. either use a small piece of sandpaper or a small mini file and file the sharp edges make em round.. u dont goota send them out and wait a week or two to do this.. itll take like 20 minutes to do both cyl.... very easy,,,, very noobie

 

 

Totally!!! But i need mine cyls to be bored out.. Only reason i sent em out!!