travis6767 Posted July 6, 2009 Report Posted July 6, 2009 last night i was gunna go ride so i started the banshee up to lad it in the back of the truck and it ran fine, i get out to the ridding spot and get it unloaded, it stars right up runs fine sounds good take it through the field and it starts cutting out on the way back, i get back to the truck and it hardly runs, just popping and sounds like shit, sounds like it is not sparking all the time, but i know for sure its getting gas, so if you have any ideas of whst this could be let me know i gotta get it fixed. and it was missfiring out both cylinders Quote
BlasterKX Posted July 6, 2009 Report Posted July 6, 2009 idk if youve done this but ive had this problem before. put new plugs in it. if that dont work check your pickup coil gap and then check your plug boots. Quote
travis6767 Posted July 7, 2009 Author Report Posted July 7, 2009 well i checked it for spark because now it doesnt run at all, and found that about 2 out of every ten kicks i get a spark Quote
BillyRay Posted July 7, 2009 Report Posted July 7, 2009 Sounds like a pick-up coil issue. Check the gap and ohm it out also. Quote
Larry's Shee Posted July 7, 2009 Report Posted July 7, 2009 Also make sure nubs on outside of flywheel for pickup coil are clean, no rust etc. Quote
travis6767 Posted July 7, 2009 Author Report Posted July 7, 2009 well i fuigured out the problem, the wires were loose in the connector where the stator plugs in to the wiring harness thanks for the help guys Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.