Hubs

[Corndiddly5885]

Wat is the best way to get the bearings out of the hubs

[2001Stroker]

A hammer and a punch. Just work it around until it comes out.

[locogato11283]

put the hubs on something solid when youre driving the bearings out and they will come out a lot easier.

[Corndiddly5885]

thats wat i have been doing but the bearings are horrible and somewhat rusted in. i put nut and bolt loosener on it and that didnt work. i pounded on it with a punch and hammer for around half an hour and it didnt move one bit

[2001Stroker]

Time to break out the acetylene. Or, you could cut out the inner race with a sawzall, and then carefully cut the inner race. If you nick the hub, it ain't that big of a deal. Just try not to, so dirt can't get past the seal, and in the bearings down the road.

[NYUK]

35 shipped for front hubs with good bearings. pm me.

[BlasterKX]

you can try using a propane torch and heat the hub up a lil bit and that would axpand it and then pound on the bearings see if that works.

[Corndiddly5885]

Time to break out the acetylene. Or, you could cut out the inner race with a sawzall, and then carefully cut the inner race. If you nick the hub, it ain't that big of a deal. Just try not to, so dirt can't get past the seal, and in the bearings down the road.

 

 

alright i will try that. thanks