33 PWK's Clearance to T5's?

[timjz]

Hello, I'm in the final stage of my Banshee rebuild & ran into a big issue. (see pics). The tops of my 33 PWK's are hitting my T5 pipe clamps. If I spin the carb, it fits, but that can't be right. I have a Boss Intake as well. Has anyone had this issue before? Thanks in advance.

[timjz]

Another Pic

[278]

I havnt heard of this happening but its good to know since after my cylinders get out of the shop I was going to run that exact set up. the only thing i can think of is use like the stock exhaust clamps

[timjz]

I should say it's only the left side carb, the right side has plenty of room.

[bbcmudtruck]

It looks to me that you could shim it at the pipe hanger and the stinger hanger. Get you some washers and shim it out from the bike a little bit. It kinda looks like its bent or misaligned anyway. My T5s align with the frame, it looks like yours curves inside it a bit on the left side.

Ryan

[jbooker82]

Mine wernt that bad when I ran the exact same setup. I did have to have the carb tilted a little though. The PWK33's fit even better with my CPI's now. Looks like my carb might have set a little farther back on the pipe.