jlaits
-
Posts
165 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by jlaits
-
Sockets are clean
-
So I found out these do have hi/low. I checked for continuity for the switches and everything checked out. Anybody have and idea what I could check for? I'm totally lost on this one
-
I was wondering if these bulbs only have low beam. When I turn on the hi beam they turn off. I checked my switch with a multimeter and everything seems fine
-
Anyways for my needle I have stock middle clip and it seems a little rich in the mid range. I thought that adding the reeds would've made it a little leaner.I couldn't imagine having to go up a clip making it even leaner. 30p stock middle clip and 320m. Toomey t5s, pods, vforce4 reeds and +4 timing
-
I wanted new lights anyways.lol. I'm going to try those tusk bulbs
-
Well I feel stupid. I went to disconnect my old voltage regulator and when I took the wire out of the loom I noticed it was unplugged. Probably from when I tighted the wire harness down with zip ties. You live you learn I guess.
-
Thanks for the info. Now on to the wanted section
-
What kind should I get? Not sure if eBay one's are garbage
-
I installed new Vforce 4 reeds and right away noticed that I needed I bigger pilot jet. I was at a 27.5 2 turns out. 30s on the way from fastracing. Anywho my question is has anybody ever needed to change needle clip position when installing these reeds?
-
Wondering if anyone has a idle screw laying around? I lost one of mine.
-
I pushed them in and put jb weld in there. They shouldn't be moving anymore
-
Anbody??
-
This backed out on me and caused my slide to get stuck open. I never had this happen before and was looking for a solution. Jb weld or some sort of silicone? Sent from my LG-H900 using Tapatalk
-
Thanks but I recently bought a good pair. I have a pretty steady hand I should be good
-
Thanks. I read Some people use a hacksaw and some use a blade. Would it help to heat the blade for smoother cut? I might as well make a test run on my old cracked boots first
-
Just orded vforce 4s through eBay from fastracing. Got them for $185 shipped because I had a $20 eBay coupon sent to me. That's why I ordered them through eBay in case you guys are wondering. Anyway I know I have to cut the stock boots but looking for tips/tricks for doing so.
-
Anyone have fitment issue's after powdercoating? I went to install the rear end and the holes and mounting spots seem to tight to fit parts. I've been slowly filing the powdercoat in those spots to get parts to slide in.
-
Tusk rear axel 200$ how is it ? Realy
jlaits replied to Yamahafan#1's topic in Jetting & Exhaust Forum
I've had mine for about 2 years and it is great. Maybe the carrier bearings were shot or the spacer wasn't installed on the ones you heard the bad about -
I broke mine and was wondering if any Yamaha one will work?
-
Any response yet?
-
I got a thumb throttle because I previously had a twist and want to give this a try. Is this piece needed for some reason other then the tors crap? Sent from my LG-H900 using Tapatalk
-
Cool thanks.
-
Where should we buy the rebuild kits? I'm going to order some soon
-
Is that another grab bar in front of the 6 pack rack?
-
Banshee Headquarters Merica Shirt
jlaits replied to locogato11283's topic in General Banshee Discussion
Look good to me. Tilt your head to the right. Star's are in the upper left corner!
