ClayAiken

soo my CPI's are coming in this week and im preparing everything for em so i can go riding immediately! im using k&n filters ( individuals ) and vf4 reeds, now i emailed mike from CPI abt jetting heres what he said: Ali, The mains will be fine at 300 to 310's cooler days have more oxygen in the air. So they need bigger jets on those days. We usually install 30 pilots and lift the needle 1 clip richer. Thanks. as clear as it sounds i have no clue what hes on about and no clue about how to install them,i mean do i screw the jets all the way in? or do i screw 2-3 threds in? and 1 clip richer? so i went to my dealership today to pick up jets, and the guy said they only offer ( 190 , 200 ,220,240 main jets ) and ( 25 pilot jet ) my elevation is below 2000m ( 1570 meters is our highest point here ), soo what the F is going on?

I have a crf 230. They dont do wheelies.

Took the tires off the tractor and stuck em on apparently.

Dont let these stupid fucks fool you. Banshees were the same from 87-06 aside from a few electrical odds and ends and changing from J arms to A Arms. Im not sure what the market is around there but all banshees are mostly the same. Year really doesn't matter.

I use these for my 1 1/8 bars. http://www.protaper.com/products/triple-clamps/bar-mounts/universal-solid-mounts

RIP

Shut up.

North East MA.

If this works like its shown if we can start spraying frames on cars/trucks that would be awesome.

Wiseco. Namura is absolute shit.

Thats sick! whos gonna be the first to try it out?

Lower and Wider would reduce the chances of rolling but I just slide off the side a little bit and go sideways through the corner as long as you dont catch anything on the ground if you stay in it you prob wont roll.

Not sure how high they are though Prob an inch or two lower than this. http://i1323.photobucket.com/albums/u584/Hyperti2/0507121841c_zpsbc038e50.jpg

i got the ATV High Bend. With the clamps that take stock stem and convert it from 7/8 to 1 1/8.

Just run Oofs.

Can never really trust what previous owners say.

I would seriously not go that route unless you want to be doing this all over again. Just use forged and be done with it.

Lift Kit, 24 Asanti's

I wouldn't use anything but Hot Rods. Not sure what he uses.

I beat his ass on my mountain bike.

Wow. That's horrible.

Any half decent tig welder should of been able to do that.

i think im faster than this guy

20mins South of Nashua.