jriffe23

http://stlouis.craigslist.org/mcy/4663905584.html 2MM STROKER HERE

Ive got 13.75 at shortest forsale. $295

Ive got a set forsale. Jussayin

Absolutely. Can't afford that. Lol I'll buy half a motor for that Sent from my iPhone using Tapatalk

^ that! Sent from my iPhone using Tapatalk

Bump! Will have pictures this weekend forsure. Most likely sunday.

i may be there. Sounds like a good time.

2 words. leak down

Hope to be racing with you all next summer. Working on a build now. Cheers

Not safe to ride if its a crank seal. Be ready to rebuild again if you disregard this comment

BUMP BUMP BUMP

Nice paint job Sent from my iPhone using Tapatalk

can i get a picture?

^ not bad but definitely not top of the line. I can do mine like that as well with some sand paper and some mothers polish

Pm sent Sent from my iPhone using Tapatalk

I was warning him because he said he was looking at buy the bearing support look at the end of the add Sent from my iPhone using Tapatalk

I'm confused then Sent from my iPhone using Tapatalk

900 shipped??

he said something about we would see pictures today. We'll see

^

The bearing support wont come with the nut to go on the sprocket. Rumor has it they are on back order but no one has received one. Read around you'll see what im saying

Yeah. No one here has sympathy for this guy, atleast not acting like that. Sent from my iPhone using Tapatalk

I agree. And how hard is it to snap a pic. If you would have called brad and say hey this crank might have spread instead of being an absolutely dick hole he probably would have helped you out. If it spread and broke the clip then it should be in the gear oil. Same with that situation. Call him and he would be willing to work with you I have no doubt. But you being a dick hole ruined your chances with that. Sent from my iPhone using Tapatalk

Ive had one time where brad didnt answer the phone. Some people have been having issues with him but everytime i call it seems to me he drops everything. Had one hiccup when i called about tie rods, but he did tell me a length and my extra yfz 450 tierods fit. Im agreeing with the guys about the case rubbing the weld, that wouldnt likely happen. Plus a guy building these motors like him will most likely not forget to little clips as i have a hard enough time trying to get mine off the main bearing in every motor i have touched

Still no pictures??