VegasJeff

was that bike red and white?

how much for the pipes? small or big bore?

pm sent.

BUMP.

I recently purchased a pancake bearing from rdz and they just sent the flat roller bearing and a washer,The ones I've bought before were complete. when installing the stock adjustment bolt with the new roller and washer,do you have to drill out the center of the preassure plate to allow the bearing to spin freely? If not it will just make contact where the hex bolt goes through the preassure plate. Thanks Jeff..

Chrome stock swingarm and carrier. $200.00 + shipping. Any questions, send me a PM.

I guess I'm the only one uncomfortable with three threads showing after the the washer has been applied. thanks for you responses.

love your clam juice pic,thats funny stuff!

anybody have advice on what head studs to use on the cub cyl? I've built a few cub motors and everytime the company I buy the stuff from always says the stock length will work and it never does.just wondering what you guys use? thanks Jeff.

Just wondering if 34pj's jetting is the same as 35pwk's? so I guess i'm asking if I'm currently 35 pwk's and running CEL needles and a main of 155 could I use that setup on 34 pj's and see the same result,or is all the jetting different cause of the 1 MIL?

OH SHIT! I can only imagine who this info is for. I will let him do the R&D on the alky,so I can upgrade later on. :yelrotflmao:

thats pretty funny right there! :biggrin:

hey thanks buddy! :thumbsup:

PM sent

I offered you 35 pwk's with manifolds for $300.00, now your paying $350.00 for smaller ones? little confused here. :shoothead:

you said the jetting went down after the install of the shears,by how much and what sizes?I have the similar set up and seems to run a little rich.

Is it 4-bolt or 6-bolt pattern?

what did ya find in there?

might be your crank,cosidering the top end is new.

I,d race ya if I had an override. just messing with ya kev, call you in a few days :thumbsup: jeff..

I agree! never do a rebuild without new gaskets and o-ring kit,just my .02 :thumbsup:

PM'd ya

Thats good advice right there! HJR told me that the shift drum bearing is useless on an overide, the overide just shifts so well without it. :thumbsup: guess when I get my overide I will be selling my drum then.

cool! would you mind throwing a pic up when you get them? I'm really thinking of getting a pair. :thumbsup:

ha ha ha :biggrin: