bamaboybv

You take $25 shipped for the rear master? Sent from my iPhone using Tapatalk

Are the pipes sold? Sent from my iPhone using Tapatalk

Is this setup still for sale ?

How much for the bottom end? if not splitting up, then how much for whole motor.

How much for just swinger?

<p>Kicker and tank to 35160</p>

Gas tanks to 35160 If they arent stripped

Did the rear caliper sell?

How much with shift drum... Pm me

Need intakes for stock-28mm carb or 28/30 mm intakes

Sell just stock intakes w/ crossover?

Rear caliper?

Yea looks like maybe rich on the pilot lean main ... So I set the timing back to 0 and leaned the pilot and fattened the main. It run like its supposed to now, but I bought the dune cylinders used, so idk who ported it. So I was always lost on the tune, I'm gonna slowly raise timing again to see if its the timing or the jetting. Then follow up from there thanks for helping

I know these were fresh plugs

I ordered some 45/138 jets scared to go leaner but plugs are still brown so idk. My timing was at +3 when i checked this morn thanks

Well I think it's a stock needle, heard they liked less fuel. The plugs are cardboard colored brown. 40:1 I think it was 32:1 on break in.

It's on a dune port, now it has 142 mains, 48 pilots. Still a bog, plugs are brown. Clip one lean. Pwk 28. 18cc domes 190 psi 110 ll. I mixed it 75/25 with 93. Running bad bogs when going to next gear.

9k stock carbs and fmfs ..............

I placed a jet order from rocky MTV atv and I forgot my pilot jets. I need 45 pilots. I would place another order but the shipping more than the order lol

Where's it located?

Need caliper and headlight/kill switch .

I need a main for each carb Looking for 140-145's

85 degrees, 700ft above sea level