bamaboybv

Need outerwears for stock carbs k n filter pods

If he backs out on the vf2's gimme next dibs

It can be a beater or project or just a roller. I need it in the Tenn. Alabama, Georgia, Mississippi, Florida era

I need a frame preferably a roller near alabama also need bottom end

$875 obo I need more money for my sbc

yea i think i need 60 over

need 65.5 pistons

$1100 obo see it here on u tube... email me for pics aabtdega@yahoo.com

It is the bike in my avatar and it has cool head 21 cc domes too. I wont part it. I just want it gone. I am building an '06 4mil super rooster

If there's anybody in alabama who wants an easy fixxer then PM me most parts are from a '05 parts bike i had when i built this one I have a 1987 j-arm banshee that needs a top end. I have 2 sets of cylinders 1 ported 1 stock they need a bore/hone. the banshee has 2 plastic sets 1 cut 1 not. timing plate dual k-n pods 2005 crank, tether kill nerfs, full FMF pipes tors removed 2005 carbs PM for details

yeah I need 65.5 new or used dont care about brand. but Wiseco pro lites are preferred

Just need 65.5's Wiseco preferably

How much for the 65mm jugs?? Were the cylinders scratched or just low compression?

Would like to trade pro design cool head 21cc + cash for good cylinders/complete top end

Anybody got some pistons with good life? Just post size/bore and condition 65.5-66.25 mm

A-Arms sold. 2 seats I have been holding 1 for a week and a half so make me an offer Pistons sold

interested in top end

Top end minus head

i got some FMF fatty's lil surface rust and right header has 2 quarter size dings on top other than that ran FINE. I am trying to get 125.00 shipped for these thanx

i got some FMF fatty's lil surface rust and right header has 2 quarter size dings on top other than that ran FINE

I spilt 'em yesterday, I found nothing. But now I'm 100% sure nothing is in there. and no I'm not lucky I've got the worst luck in the world. I will probably try a 4 mil setup but idk thanx for input

I wasn't expecting that, I WILL TAKE $80 shipped

115 obo gotta sell

Naw i think loco was confused on which circlips I meant. Maybe i could have been clearer I was talking about the piston (wristpin) circlips, not trying to be a dick cuz loco has helped me plenty of times even when i was being a dick. So I will always ask for and respect his opinion POINT BLANK he know's I speak that Alabama mumbo jumbo

WTF?? I think you're confused loco, i have and will always respect your opinion but I think you were reading or typing too fast. Circlips keep the wrist pins in the piston which is all the top end. I lost one and it got chewed up and most of the time they fall in the bottom end. I was asking if anyone had any nice tricks to avoid splitting my cases to get the missing clip out. There are 4 I only found 3. I dont know what you mean "what do the circlips have to do with the top end?" you must have meant bottom end ???? IDK what you're talking bout loco. we need to get on the same page. Do you see what I'm saying now??? basically top end blew, because wrist pin went through circlip and I only found 3 circlips and there is only 1 place to look for the other(the bottom end, but i didnt wanna split the cases)