wildbansheeboy

Put all the old springs back in !

ART'S SNOWMOBLE & ATV CORNELL,WI 1-715-288-6863 They have all kinds of used parts 4 almost any snowmobile & quad they ship the parts right to your door

THANKS

I have used both fattys and PC and I think the fattys pull harder on the low end mid pull the same and PC pull harder at the top .My buddy has Moto Fast 2 in 1 pipe and makes tons of low-mid power . Dropping down in gearing is also good idea. Check Ebay 4 great deals on pipes u will save lots of $

I GOT A SHEE LOWER END (CHEAP)AND I WAS TOLD THAT IS A 4MM STROKER IT HAS HOT RODS AND HAVE 121 ON ONE SIDE OF THE ROD.BUT NO PLATE AND THE PISTONS WERE VITOS AND WERE SHORTER THEN STOCK.WHAT KIND OF PISTON IS USED IN A 4MM STROKER?

I RUN A 8 BLADE PADDLE SIZE 22X11X9 IN SAND AND 20 INCH HOLE SHOTS ON DIRT/GRASS MY MODS ARE 35MM KEIHIN AIR STRYKERS WITH OPEN K&N FILTERS,20CC DOMES IN A COOLHEAD,STAGE6 PORTING DONE BY A&S,30. OVER WISECO PRO LITE PISTONS,BOOSTBOOTLE,3/8 INCH REED SPACERS, RAD VALVE REED CAGES ,1000RPM OVER STOCK CDI BOX,PRO CIRCUIT PIPES AND A TIMING PLATE ON THE WAY. THE SHEE HAS BEEN LOWERED 3' AND AND RACE CUT FENDERS THE REST IS STOCK .THANKS TO ALL WHO HELP

The tires I use are paddles 22x10x9

What is the best gearing set up 4 300ft drags?Is it better to go low and start in a higher gear or is it better to go high my banshee has lots of mods but this gear thing is one thing I am still working on right now I have a 13 on front and 44 on rear and start in 2nd but I think I can get better times if I play with my gears .Any Ideas?

Any Ideas where I should start with my timing + or- ?

I am looking 4 info on hot rods stock stroke!Do they give the shee more power?