banshee76179

R.I.P.

Getting a new Head HuH! U need 1 ....J/k Scott!!!!!

Tried everything from 38 to 52 samething.. Thanks new Stator Led, I've tried the carb. cleaner when it's running..I don't know of any other way for checking for a air leak..

It's like it getting too much fuel..popping,sputtering and falling it on its face. setup.. 2 into 1 carb 33mm keihin carb trinity stageIV intake/carb setup V-forceII ..Stage IV intake Stage IV head 20cc/165 lbs

the truth hurts sometimes, But U have to let'em down easy though! LOL

All right now, I'm totally lost and I'm pissed Still doing the same thing two different set no 3 different set of reeds,2 different carbs(2 into1) and every set up does the samething.. Anybody else got any clues.... for my final conculsion would be electrical now.. heres another list. New Stator/flywheel Msd ignition new plugs Tried stock ignition Thanks, Chris

k & n

Bike.--165 car.--155 w/top down boat.--80 rough on the back banshee.--80+

85.85

I'm with blue on this one. Man you would have to have one pissed off banshee to go over 100mph, I just don't see a stock banshee, hell I don't see a piped and ported banshee with stock gears getting anywhere near 100mph. If you have one I want to see you go 100mph and then take your engine apart. me neither..

Yeah Led, I read ur post on another post about reeds..I'm going to take out my V-force and put my old Boysen in and see if that helps.. maybe

mid to high 70's maybe 80 hell I don't know, fast enough 4 me...15/41 gears..22in tires

I thought so to, so I tried the carb cleaner trick but, it didn't raise the idle.. So, I didn't think it was a air leak but, I'll check it again .. Thanks

Pinging...denotes low Octane....whats ur compression?

Me tooo........

Good 1...Yeah I have a guy here that did the same thing and it ended up the sameway..man its priceless...

Tried it ...but, thanks though!

it'll start fine w/my new carb now "bought it from buddy".... but, it won't idle...but, same situation When its warm U nail the gas it falls right on its face..to much Gas/ but acts like it's lean on the pilot popping/sputtering it was lean w/38 then all the way to a 52 then the plugs look black&wet so I went backwards to a 50 and adjust the airscrew... same....Same thats when I started looking in the other direction other than the carb..but, all indications point to the carb.."does that sound right" I getting pissed at her right now...

No, Scott, it's not like that,..like U had a pretty bad wreck broke 4 ribs/tweak back...yada Just, got back into her..."healed now." Comp, 155LBS both.... And she runs pretty good on the top end.... And I really have't tried the throttle wide open yet got to pissed

Dido!

Also. the new carb I can't get it to start.. I need to spray alittle carb cleaner in her to get her to fire up..

I would try to bend it back... My buddy bent his in the same place we used a 2x4 and a car jack and bent it back it works fine.. just depends on how bad it bent "his was pretty bad." Unless U can get ahold of another frame$$$$

list of mods in sig. I'm totally lost now... Heres the deal the past 3 weekends I have had this 1 problem that is haunted me. It's a low end bog like it getting fuel dumped but, it kind of clears up on the upper rpm range. So, I thought it was the carb/pilot/air screw.. I have adjusted from 38 clear to a 52 on the pilot.. still the same..So, I had a buddy who had another 33mm pwk so I tried that..And, The same damn thing. So, I try getting a new stator"200w" Ricky Stator and same thing, So, I figure ignition..Maybe MSD acting up..So,I put the factory back on and the same thing. Then, maybe Reeds.Nope reeds r good not cracked or opened.. v-forceII two months old It runs decent "not to its potential" when cold but, when it warms up and U nail the throttle, its falls on its face start popping like its "lean" and spuettering... Air filter is K&n clean/in box no lid... Carb is 33mm keihin pwk 42pilot/180main/needle 4th clip/air screw 2 turns out elevation 600 no tors Sorry for the long post..If I missed anything,tell me and I'll try and get u the right info.. thanks guys

Bush...