205GTINUT Posted December 13, 2006 Report Posted December 13, 2006 Hi there i took the plastics, tank, seat, exhausts off my banshee to give it a wash. I washed every where with a little brush and a dab of petrol. I covered the hole to the air box and covered the holes at the head where water could get in. Now the problem i have built the bike back up together put a fesh gallon of petrol in it hit it one kick and it fired up no trouble, i then let it idle for 5mins went to give it a full rev and it wouldnt take it. I have checked the throttle cable-plugs-petrol pipe. The bike will idle all day but no reving. Can any one help? Quote
HotCarl Posted December 13, 2006 Report Posted December 13, 2006 It sounds like you left the parking brake on. Quote
Ting Ting Posted December 13, 2006 Report Posted December 13, 2006 Make Sure that you don't have the e brake on becuase that will not let you rev up that all. Quote
205GTINUT Posted December 13, 2006 Author Report Posted December 13, 2006 Make Sure that you don't have the e brake on becuase that will not let you rev up that all. Guys i removed the parking brake during the strip? Do i need to put it back on the bike again?? Quote
Bansh-eman Posted December 13, 2006 Report Posted December 13, 2006 Guys i removed the parking brake during the strip? Do i need to put it back on the bike again?? no its not needed, as long as you follwed the wire down under the plastics and unplugged it then your good. Quote
205GTINUT Posted December 13, 2006 Author Report Posted December 13, 2006 Thanks for your help fella. Problem now totaly sorted! Thanks again. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.