hotrodbanshee Posted December 10, 2006 Report Posted December 10, 2006 Fixing to install new v-force v3's. When holding them up to a light is it normal to see little pin holes in the carbon pedals? I noticed some light shining through on mine. These are brand new. Quote
Barrymaxx Posted December 10, 2006 Report Posted December 10, 2006 Well they are very thin, so some light will shine through, but i never herd about small holes. My boyesens dont have them, i had them out today. Someelse would know better Quote
Bansh-eman Posted December 10, 2006 Report Posted December 10, 2006 Fixing to install new v-force v3's. When holding them up to a light is it normal to see little pin holes in the carbon pedals? I noticed some light shining through on mine. These are brand new. what you are seing is normal...but its not holes... the carbon fiber is thin where the strands of cloth cross one another... thats where the lights passing in at... Quote
Washburn Posted December 10, 2006 Report Posted December 10, 2006 what you are seing is normal...but its not holes... the carbon fiber is thin where the strands of cloth cross one another... thats where the lights passing in at... Got that, Also make sure when you file down the rubber off the intake manifolds and hold the reeds up against them check to see if you can see light shining through. If you see any light that means you dident file them down good enough to create the proper seal. Quote
hotrodbanshee Posted December 10, 2006 Author Report Posted December 10, 2006 Thanks guys. After I posted I went to v3's web site and under FAQ's I got the same answer. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.