Lockup clutch cover is on! Foot peg problem?

[RV00GT]

Finally got the lockup clutch and cover installed and now the darn foot peg will not go on. The foot peg hits the clutch cover. Anyone had this problem?

[lowriderb]

you could possibly cut down the foot peg a little or get a little bit longer bolts and cut some spacers for it which is the route that i went because my pegs are chromed..

[RV00GT]

I thought about spacers. I wonder if someone makes a foot peg that will bolt right up?

[odaen]

www.directdrivecnc.com

 

They make some pegs that will most likely bolt right on. From the pictures, it doesn't look like they are very "beefy" though.

[FASTOYS]

Are you using Direct Drive units as that is what we sell and dont have much problems . Just need to adjust the brake lever alittle and that is it.

[race-a-holic]

How do you adjust the brake lever?

[[email protected]]

I thought about spacers. I wonder if someone makes a foot peg that will bolt right up?

512697[/snapback]

 

 

i got aftermarket foot pegs with the case and yes u gotta grind away and i added spacers aswell..... u can see just how close the clearance is in this next pic

 

[BansheeBrian]

It was a close call with my stock pegs but grinding down the excess steel on them did the trick.They cleared even with the chrome.

[Big Blue]

I used some washers to space mine out.

 

[bigboybanshee]

That's nuts...mine went on fine with the stock pegs, no spacers, no grinding, no problems. I got about a quarter inch clearance between the peg and the cover. Weird

 

I do need to adjust my brake lever though, it barely rubs the bottom of the cover