lastlegwarrior Posted January 30, 2006 Report Posted January 30, 2006 i was just wondering what to do about my little predicament, i was planning on pulling apart the shee and rebuilding/bore/ porting the shee for summer, but when i was taking off the top end i noticed that the pistons were already a .50mm overbore. Should i still go ahead and port the shee even though the cylinders are .50mm over or what, need some advice on what to do. thanks in advance. Quote
locogato11283 Posted January 30, 2006 Report Posted January 30, 2006 u can justbore them to the next size, thats no big deal..what kinda riding are you doing?? might be worth checkin out some cubs if you dont need an assload of low end power... Quote
lastlegwarrior Posted January 30, 2006 Author Report Posted January 30, 2006 yeah i know i could go ahead and go to the next size but isn't that about the last bore i'll get on these cylinders? So wouldn't that be like almost wasting a port job? Quote
Shee_Rookie Posted January 30, 2006 Report Posted January 30, 2006 I may be wrong, but I think you can go as far as .80 over. Quote
NYUK Posted January 30, 2006 Report Posted January 30, 2006 ported cubs will be a few hundred more than a quality port job bore and pistons, it`s the wave of the future.if i was in your situation i would look that way. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.