aguita Posted January 18, 2006 Report Share Posted January 18, 2006 i have a friend that is looking for the studs so he can install his head we tried prodesign and no luck!! where can i find this?? thanks Quote Link to comment Share on other sites More sharing options...
Tim C Posted January 18, 2006 Report Share Posted January 18, 2006 (edited) I bought them directly from Pro-Design - but it was a while ago. Any place that specializes in bolts etc. should have be able to get them for you - they're a common metric thread. Edited January 18, 2006 by Tim C Quote Link to comment Share on other sites More sharing options...
brock_fuzzy_69 Posted January 18, 2006 Report Share Posted January 18, 2006 i was always tempted to go to the chevrolet dealership to get some they use a special stud on there exhaust manifolds etc. has an external torx head on it to use when threading them in Quote Link to comment Share on other sites More sharing options...
BrianEb Posted January 18, 2006 Report Share Posted January 18, 2006 Call Vito's there studs are the same lenght as the Pro Design. out Quote Link to comment Share on other sites More sharing options...
fast87 Posted January 18, 2006 Report Share Posted January 18, 2006 a local hardware store like ACE should carry em in those small nut/bolt bins in the back...i've seen em there before, not sure about length but bring in something to measure the threads...i'm pretty sure it's a 8 x .25mm thread but dont quote me on that ~Mark~ Quote Link to comment Share on other sites More sharing options...
BansheeGuy_IV Posted January 18, 2006 Report Share Posted January 18, 2006 Hrrmmm... IF you look at Pro Design studs... The smooth "shaft" is a little bit larger than the threaded area so that the O-rings make a tight seal. They're alot harder to match up than one would think. I had the same issue recently and Pro-Design told me they didn't make extra studs because theirs were "lifetime" and if i wanted to wait some unknown length of time they might be able to get me some. So I told them to bite me and I bought a new head that uses stock studs ;-) BG Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.