nology coil installation?

[RMX250DB]

I just bought the nology coil from kd cycle which seemed like the place to get it from. I'm trying to figure out how this goes together since the only directions it came with were how to attach the coil. It came as the coil in one box, a blank plug wire, a cap and thats about it. I have a cap screwed onto each wire blank, but was wondering how to do the other end. Ive attached a picture, pretty much what im asking is do i strip the insulation off one end of the plug wire to crimp on that clip.

 

[Shee-Male]

Cut back the casing approx 1/2-5/8" take the wire core and fold it back along the wire itself, place the terminal clip overtop the wire core and crimp on.

The crimp will look like an M shape (curling each side of the clip in to the center)

if it didn't come with a crimper most elec. crimpers will have a "ignition terminal" spot.

Use a little silicone spray to lube the boot to slide it over the wire.

Hope that helps

[fast87]

how much was that coil?? and whats with the mounting tabs, do you have to drill through the frame and use a nut on the other side? or just use one mount hole?? looks like a sweet setup to me

 

~Mark~

[RMX250DB]

Thanks Shee-Male, coil is installed and working now.

 

Fast87- I think i paid 120 for the coil, i only used one mounting tab right now since it seems to be pretty secure, i may make a bracket to hold it on the other side.

 

Tom