Jump to content

Recommended Posts

Posted
:cry: Hello All, Hope someone out their has an answer to my prob. My Banshee will start and idle but it has no rev. Acts like the parking brake is on, but its not, I even disconnected the wiring to it. I traced the wiring back to the CID module, Could that be the Problem? Please help if you can. Thanks Dave
Posted

TORS = Throttle Override System = Worthless Piece of Junk

 

TORS was designed to prevent the throttle from sticking, it causes more problems than its worth.. just disconnect it and then go out and get a TORS eliminator kit.

Posted

Looks Like I may have found the problem and saved $60 dollors in diagnostic fees

 

TORS(Throttle Over Ride System) the main purpose of this is to keep you engine from blowing up if one slide gets stuck in the open position. There are sensors on top of each carb that senses the position of the slide in the carb. There is a sensor in the throttle housing that senses the position of the throttle. The sensor in the throttle housing and on top of the carbs sends a signal to a box(Located under the gas tank on the left side of the frame). When the position of either carb or the throttle position and carb slide positions don't match then the box will send a signal to the ignition box and the ignition will be adjusted to keep your engine from blowing. In another words......get rid of it because when it gets wet enough it will reak havoc and become a huge headache. Plus when you get rid of it and put in a TORS eliminator kit the throttle response becomes alot better.

 

It ran fine 2 days ago, then yesterday my Son washed it.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...