Headlight replacement ?

[milo_32000]

Got tired of buying Banshee headlights, so I bought 2 automotive rubber mounted lights with 4411 bulbs which are 35 watt, the 4411 lights only have 2 wires and the Banshee has 3 on the left side whice are green, black & yellow, the right side has green & yellow, which or what wires do I use , Thanks, Milo

[Ultimateduner]

Not sure but I think 35 watt might be a little much for your stator. Any ways my recommendation would be to try the different combinations of wire until you have what you want.

[Bansh88]

2 35s is the best! You will no longer have high/low beam. Just on or off. not sure which colors go where though. my girlfriend wired mine up.

2 50watts would be too much

[Wallrat]

black is the ground, yellow is for the high beam position, green is for low beam position. Personally I prefer to have the lights on in the high beam position. To do this, connect the ground on the lights to the black wire, and the yellow wires to the positive on the lights.

[northshore]

black is the ground, yellow is for the high beam position, green is for low beam position.  Personally I prefer to have the lights on in the high beam position.  To do this, connect the ground on the lights to the black wire, and the yellow wires to the positive on the lights.

450854[/snapback]

 

agree

[milo_32000]

Thanks for the help, just was not sure of the ac/dc thing, will install them and see what happens ! Kinda got tired of the stockers, they were kinda like homemade time bombs !!! never knew if they were going on or off !!! milo