Brian G Posted August 17, 2004 Report Posted August 17, 2004 Guys, I cannot find my damn manual!!! do any of you know what the torque is for the flywheel nut? I think it is 40 lbs but I am not sure, If any of you know I would really appriciate your help. Thanks Quote
locogato11283 Posted August 17, 2004 Report Posted August 17, 2004 i just tighten it down with an impact till it wont move anymore Quote
yama_banshee Posted August 17, 2004 Report Posted August 17, 2004 i just tighten it down with an impact till it wont move anymore ive done that before and had bad results but you should probally use a 80lb tourque stick when tightening it down Quote
J-Madd Posted August 17, 2004 Report Posted August 17, 2004 I tightened mine with a ratchet by hand, then hit it with a hammer............been riding like a maniac and it hasn't popped off..... Quote
nater006 Posted August 18, 2004 Report Posted August 18, 2004 Strap wrench to hold it, and a 1/2" drive 150 ft/lb torque wrench to snug it to spec. Quote
ledofthezep Posted August 18, 2004 Report Posted August 18, 2004 Tight & then a little. Works for me... Quote
racer Posted August 18, 2004 Report Posted August 18, 2004 i just tighten it down with an impact till it wont move anymore i did that last time i replaced my timing plate and now it wont come off. at all. just stripped my puller tryin to get it off. f*ck. anyone know if it can be safely warmed with a torch to loosen the fit a little? Quote
Paywon87 Posted June 21, 2021 Report Posted June 21, 2021 On 8/18/2004 at 7:11 AM, nater006 said: Strap wrench to hold it, and a 1/2" drive 150 ft/lb torque wrench to snug it to spec. Then a 1/4 turn? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.