new build looking for a little info

[Jimbo123]

Looking at this kit but cant find any info on it. some insight would be greatly apparated as this is my first build. 

373cc ASSASSIN Cylinders Banshee TOP + BOTTOM END Vito's 4mm crank 513 pistons

[fastbanshee8]

Stay away from rattle can Ray, aka Minkia38.  Contact one of the forum sponsors, and buy from them.  You'll get your questions answered, good parts, and much better support.

[Jimbo123]

thanks for the reply will search hear cheers.

 

[Keno]

I would stay away from that. Apparently it is a set of Driveline Cylinders that now have steel sleeves pressed into them.

[BANSHEE HP]

Were doing cylinders with steel sleeves now. 4mm stroke 64mm starting bore.

Sent from my SM-G965U using Tapatalk

[Keno]

Were doing cylinders with steel sleeves now. 4mm stroke 64mm starting bore.

Sent from my SM-G965U using Tapatalk

Oh, well good to know. Didn't see them on your website. Welp, shouldn't be an issue then.
Are they HP or LP?

[BANSHEE HP]

Oh, well good to know. Didn't see them on your website. Welp, shouldn't be an issue then.
Are they HP or LP?

Theyre 192° exhaust port. Kinda an in between'er but low 190's is what we've had good personal experience with. Its been super hard to keep the website updated or even add cylinder kits to it before they're already sold/spoken for with the parts shortages and the extremely long wait time on plating. Partially why we made a sleeve to install in our casting. All the labor of installing, port match, bore and hone is done in house vs sending them to plating at Millennium for almost 3 months.

Sent from my SM-G965U using Tapatalk