Crank bearing pin

[jse28]

Putting motor together and noticed left side pin/stop is missing. Are they replaceable?

[Ayesully810]

is it a stock crank with oem bearings? 

[Keno]

If your bearings have o'rings, you don't need the pins.

[Ayesully810]

8 minutes ago, Keno said:

If your bearings have o'rings, you don't need the pins.

this is what i was getting at

[jse28]

I got it. A little sleeve retainer will do the trick I’m told

[BigRed350x]

It is just a small roll pin tapped into the outer bearing race.  You can pick up roll pins from most hardware stores.  You could just get a new one and tap it in with a little hammer and you would be good to go.  With how small that pin is, I would guess it would cost less than $1 to buy.

[kawa110]

I’ve seen some nice write ups by you

Thanks

[BigRed350x]

7 hours ago, kawa110 said:

I’ve seen some nice write ups by you

Thanks

Thanks!  Thats all pretty old stuff now-a-days.  I'll have to do an updated one with some of the little tricks i learned over the years.