Yamaha_Banshee_Living Posted October 7, 2016 Report Share Posted October 7, 2016 I have a 2004 banshee that i plan on putting alot of money into over time. But at the moment im playing with the idle screws and all that jazz but i loosen the idle screws all the way,so there not touching slides and then slowly screw them back in till they just start to touch the slide but one screw touches the slide before the other. Is this normal? 1 Quote Link to comment Share on other sites More sharing options...
Yamaha_Banshee_Living Posted October 7, 2016 Author Report Share Posted October 7, 2016 Like one i have to screew in really far to get it to touch and the other not so much Quote Link to comment Share on other sites More sharing options...
stpltn Posted October 7, 2016 Report Share Posted October 7, 2016 Are the screws the same length? Quote Link to comment Share on other sites More sharing options...
Yamaha_Banshee_Living Posted October 7, 2016 Author Report Share Posted October 7, 2016 Yes they are the same length Quote Link to comment Share on other sites More sharing options...
hoppedupandcutdown Posted October 7, 2016 Report Share Posted October 7, 2016 Maybe one carb had more filed of off that nub for the jam nut than the other. 1 Quote Link to comment Share on other sites More sharing options...
J-Madd Posted October 8, 2016 Report Share Posted October 8, 2016 Doesn't matter. Just make sure slides are raised the same amount. Quote Link to comment Share on other sites More sharing options...
Yamaha_Banshee_Living Posted October 8, 2016 Author Report Share Posted October 8, 2016 (edited) Ok thank you thats what i was thinking just wanted to make sure Doesn't matter. Just make sure slides are raised the same amount. Edited October 8, 2016 by Yamaha_Banshee_Living Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.