hoppedupandcutdown Posted January 13, 2016 Report Posted January 13, 2016 I would say if it runs that the flywheel is doing its part. You did test for voltage at the bullet connectors with it unplugged from the rest of the harness? Correct? 1 Quote
Dixie normus Posted January 13, 2016 Report Posted January 13, 2016 Test stator. I know a guy that can rewind the lighting side Quote
sleeper06 Posted January 13, 2016 Report Posted January 13, 2016 Test from each wire to ground on stator , should get o/L if you get resistance its bleeding , I was gonna say light switch but if your testing at the leads off stator that eliminates that and doesn't leave anything else but stator, if the bike runs fine I would assume the flywheel magnets are good but wouldn't hurt to check if you had a buddy with a known good one Quote
DESTRUCTIVE Posted January 13, 2016 Author Report Posted January 13, 2016 (edited) I tested the stator at the bullet connectors, and no voltage Edited January 13, 2016 by DESTRUCTIVE Quote
DESTRUCTIVE Posted January 13, 2016 Author Report Posted January 13, 2016 Where is the ground on the stator at and what do you mean o/L Quote
Dixie normus Posted January 13, 2016 Report Posted January 13, 2016 (edited) Ohm the stator windings (black to yellow) with bike off. Report back Edited January 13, 2016 by Dixie normus Quote
DESTRUCTIVE Posted January 13, 2016 Author Report Posted January 13, 2016 With bike off if I get .2-.3 Quote
Dixie normus Posted January 13, 2016 Report Posted January 13, 2016 Hmm. Odd. That ohms about right. Is your meter on AC voltage when checking for voltage (engine running)? Quote
sleeper06 Posted January 13, 2016 Report Posted January 13, 2016 ^ check multi meter setting before you chase other parts Quote
DESTRUCTIVE Posted January 13, 2016 Author Report Posted January 13, 2016 Ya it's for AC I tried 3 different meters also with bike running Quote
hoppedupandcutdown Posted January 13, 2016 Report Posted January 13, 2016 I'll ask again, with the rest of the bike UNPLUGGED to isolate from a grounded out wire or switch? And manual says to check with a DC voltmeter, the bulbs are DC Yes, I know the stator puts out AC Quote
DESTRUCTIVE Posted January 13, 2016 Author Report Posted January 13, 2016 (edited) Hoppedupandcutdown, I have have the black and yellow from the stator unplugged right now. I checked AC&DC at the black and yellow wires and nothing. What to you mean by unplugged Edited January 13, 2016 by DESTRUCTIVE Quote
Dixie normus Posted January 13, 2016 Report Posted January 13, 2016 Check wiring. If wiring checks good and no voltage out of stator leads. Bad stator. Quote
DESTRUCTIVE Posted January 13, 2016 Author Report Posted January 13, 2016 Ok I just bought it from eBay so maybe that's why. Is there a good place to get a stator for my bike Quote
hoppedupandcutdown Posted January 13, 2016 Report Posted January 13, 2016 Have you heard of http://www.bansheehq.com/ ? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.