Shee_fast Posted January 3, 2016 Report Posted January 3, 2016 I got this basket in a tot of parts, looks like it was rubbing on something. I was wondering if it's shot or maybe useable.. Its grooved around the basket as you can see. Just need some input Sent from my VS810PP using Tapatalk Quote
trickedcarbine Posted January 3, 2016 Report Posted January 3, 2016 Meh, first issue is making sure you have the matching primary gear that goes on the crank snout. The basket is self doesn't look so hot. The mark outside isn't a big deal, but the chatter grooves in the fingers are a bit of an issue. They make engagement of the clutch feel very chattery or clunky. You may be able to file some of the inner finger to smooth it out, but ultimately a new basket would be best. Quote
Shee_fast Posted January 3, 2016 Author Report Posted January 3, 2016 It's a billet basket so I didn't know if it was salvageable, but thanks for the input. As far as primary gear are you talking about the small one on the crank? Sent from my VS810PP using Tapatalk Quote
Shee_fast Posted January 3, 2016 Author Report Posted January 3, 2016 YesIt lines up yes.. I put it the motor for,mock up...but I guess I'm going to see if anyone has a basket they wanna trade some thing for Sent from my VS810PP using Tapatalk Quote
n2otoofast4u Posted January 3, 2016 Report Posted January 3, 2016 If you're on a budget give that basket a little love and run it! 1 Quote
sheerider11 Posted January 3, 2016 Report Posted January 3, 2016 It lines up yes.. I put it the motor for,mock up...but I guess I'm going to see if anyone has a basket they wanna trade some thing for Sent from my VS810PP using Tapatalk It's always going to line up. But there are numbers scribbed on each. Take the 2 and divide them I believe and that'll give you gear lash. It needs to be within a certain spec as per the manual 1 Quote
trickedcarbine Posted January 3, 2016 Report Posted January 3, 2016 ^ they are marked. Make sure they are matched. Quote
Shee_fast Posted January 3, 2016 Author Report Posted January 3, 2016 I'll post a pic Sent from my VS810PP using Tapatalk Quote
Shee_fast Posted January 3, 2016 Author Report Posted January 3, 2016 Is this what were talking about and, I'm not sure what numbers were talking about Sent from my VS810PP using Tapatalk Quote
Shee_fast Posted January 3, 2016 Author Report Posted January 3, 2016 Note my cases are not bolted together yet either Sent from my VS810PP using Tapatalk Quote
registered user Posted January 4, 2016 Report Posted January 4, 2016 normally its not good to have rust on the face of those teeth. if its very light surface rust you might be ok be if its gone down farther you probly have a bunch of pitting pretty soon 1 Quote
Shee_fast Posted January 4, 2016 Author Report Posted January 4, 2016 Doesn't seem too bad might just be from being in a tot... So if I decide to file the fingers down do I do the whole finger til groove is gone? Sent from my VS810PP using Tapatalk Quote
Shee_fast Posted January 6, 2016 Author Report Posted January 6, 2016 .. Sent from my VS810PP using Tapatalk Quote
Shee_fast Posted January 6, 2016 Author Report Posted January 6, 2016 Should I file it flat with the grooves if I were to run this? Sent from my VS810PP using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.