Hunter3473 Posted March 27, 2015 Report Posted March 27, 2015 So I went to change the bearings in my swingarm today and the bearings are shot but the racers are almost seized into the swingarm. Any ideas how to free em up. I have tried to search this on the forum and nothing came up. Sent from my VS985 4G using Tapatalk Quote
Hunter3473 Posted March 27, 2015 Author Report Posted March 27, 2015 Thanks man but my pivot bolt came out easy. I just need to get the racers out now Sent from my VS985 4G using Tapatalk Quote
Hunter3473 Posted March 27, 2015 Author Report Posted March 27, 2015 Sorry about that dubecat didn't realize you were a girl Sent from my VS985 4G using Tapatalk Quote
ScEaMin BaNsheE 305 Posted March 27, 2015 Report Posted March 27, 2015 recently did mines, I used a thin flathead screwdriver like chisel till you fold the rings of where the bearing needles use to sit. Quote
Hunter3473 Posted March 27, 2015 Author Report Posted March 27, 2015 Ok great thank you so much And sorry for spelling your name wrong dam phone Sent from my VS985 4G using Tapatalk Quote
Hunter3473 Posted March 27, 2015 Author Report Posted March 27, 2015 After trying a dremel I couldn't get the races cut. There rusty looking and by the looks have been in there since the bike was new. Sent from my VS985 4G using Tapatalk Quote
Hunter3473 Posted March 27, 2015 Author Report Posted March 27, 2015 Got em out with a small screwdriver and a propane torch deff gonna install a zerk for grease in the center Sent from my VS985 4G using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.