Banshee not getting fuel

[Leroy1911]

My banshee has a fresh top end rebuild rebuilt the carbs but won't start

Carbs have fuel in them my choke tube is connected did a leak test and it is good

Have lots of spark... And it will fire if I spray fuel in the carbs but won't run other wise

 

Any ideas???

[bigweav81]

If it will fire up like you say, and stay running. You may want to check out your choke plunger.

[Leroy1911]

No it won't stay running it just fires on the fuel I spray in the carbs then dies

[Larry's Shee]

Correct float bowl on correct carb? Slides in correct carb? Double check float level. Fuel going into bowls?

[oldskool]

This^^^ and make sure pilot jets are clean, sync carbs.Where are air screws at? Welcome to BHQ

[banshee4mil]

If it will fire up like you say, and stay running. You may want to check out your choke plunger.

you dont know shit so dont tell ppl to check their chokes

 

 

--leroy- pull out the poilot jets and clean them , bet it will start and stay running, then, the pilot jets are the small straight screw driver jets, these always get clogged after setting first thing to check anytime you clean a carb-

[sleeper06]

Or pilot is too small

[trickedcarbine]

Have you checked that the old petcock is actually flowing fuel?

Often old Un checked ones have a strainer that sits inside the tank. They can get pretty goobered up. Just tug it and be thorough about your fuel habits so as to not get dirt in it.

[Leroy1911]

The petcock is cleaned but I will check my pilot jets

 

Thanks for the help