Hey does any body kno how to read these #drill bits

[nito.hernandez1]

It 1-60 an im trying to make my own alky carbs just dont have the chart to figure out wich one is 0.119-0.120 an so on

 

 

Sent from my iPhone using Tapatalk

[trickedcarbine]

http://www.custompartnet.com/drill-size-chart

 

#31 is .120

Edited November 27, 2014 by trickedcarbine

[nito.hernandez1]

Ok thanks

 

 

Sent from my iPhone using Tapatalk

[n2otoofast4u]

I'd double check them with calipers before using....

[nito.hernandez1]

 

 

Sent from my iPhone using Tapatalk

[nito.hernandez1]

Can anybody tell me if these are the correct bits to use to set up alky carbs

 

 

Sent from my iPhone using Tapatalk

[nito.hernandez1]

Yes i measured #31 an it gives me 0.120

 

 

Sent from my iPhone using Tapatalk

[trickedcarbine]

^ there's your answer.

[rubberneck]

Wait...  so you had the means to measure it the whole time?

[nito.hernandez1]

Yes just wanna kno if im doin everything right it doesnt hurt to ask to make sure what your doin is correct

 

 

Sent from my iPhone using Tapatalk

[JTmachining]

Drills can drill oversize often (.001-.002). Not sure wat equipment ur using to do dis but start small and step to the nxt size as needed.