roblipka6banshee Posted September 20, 2014 Report Posted September 20, 2014 I have 2 06' banshees one is special edition and both have different mods and both have tors removed. My problem is as soon as I go through even a little bit of water they bog down and quit on me, start them up rev em for a bit and I'm good to go again. Something must be getting wet? Sent from my iPhone using Tapatalk Quote
ETR174 Posted September 20, 2014 Report Posted September 20, 2014 Are you going fast through it and what air filter set up? Quote
trickedcarbine Posted September 20, 2014 Report Posted September 20, 2014 Brake clean and Dielectric grease on all connections Better filter set up with outer wear Quote
sleeper06 Posted September 20, 2014 Report Posted September 20, 2014 Check both stator side covers if it gets wet in there it will ground itself out , I have actuall worked on few that have trapped water. My ohm meter was going crazy and I narrowed it down to that. Obviously check all of harness for tears and possible shorts good luck Quote
03DMshee Posted September 20, 2014 Report Posted September 20, 2014 When tors were removed was the harness removed and all wires cut out completely? My guess is they cut the wires off flush at harness wrap and the water is connecting a circuit. ... Also remove your green/yellow wire from CDI so no future issues.... Quote
roblipka6banshee Posted September 26, 2014 Author Report Posted September 26, 2014 Thanks, you guys have givin me some good spots to start. Both have k&n one is quite suped up no air box and plastic has even been cut but has outer wear on and it gives me the least issue. Sent from my iPhone using Tapatalk Quote
ETR174 Posted September 27, 2014 Report Posted September 27, 2014 Well that's probably why is because it is getting in your air filter. If you are running pods make a custom air box out of scrap metal or something and cover it all around. Just leave an open top. Either that or put the stock air box back on, take the lid off and possibly rejet. Someone will have to confirm the rejet. Quote
roblipka6banshee Posted September 28, 2014 Author Report Posted September 28, 2014 One has the filter box still and is worse Sent from my iPhone using Tapatalk Quote
03DMshee Posted September 29, 2014 Report Posted September 29, 2014 Did you remove the harnesses and go through the electrical? Quote
roblipka6banshee Posted September 30, 2014 Author Report Posted September 30, 2014 No I haven't I'm going to start with some easier stuff. Didn't really want to take it that far apart but if that's what it comes to I'm saving that as last resort haha. Sent from my iPhone using Tapatalk Quote
03DMshee Posted September 30, 2014 Report Posted September 30, 2014 Your harness takes about a half hour tops to remove.... Quote
ETR174 Posted September 30, 2014 Report Posted September 30, 2014 Its a bitch to get it all out because you have to remove the front plastics and gas tank but that's about the only other explanation. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.