bigweav81 Posted August 15, 2014 Report Posted August 15, 2014 rule of thumb is to always start fat and work your way down. Quote
02Bansheeee Posted August 15, 2014 Author Report Posted August 15, 2014 Alright, that'll be my new wheel chock when I order the crossover tube. & with the cylinder walls other than scoring, which there doesn't look or feel to be, what should I do about it? Hone it? Quote
bigweav81 Posted August 15, 2014 Report Posted August 15, 2014 stock style cylinders right? that's up to the shop you take it to. send it to a site sponsor, and get it ported. Quote
02Bansheeee Posted August 15, 2014 Author Report Posted August 15, 2014 Yep, stock style. & alright. That's up to my brother, how much does porting usually run for eh... Say a mx port? Or a trail port? Quote
bigweav81 Posted August 15, 2014 Report Posted August 15, 2014 how much? lets say this good work isn't cheap, and cheap work isn't good! who ever can tell you whats best for you. well going to knock the stuffin off the wifes muffin, and eat supper good luck. start a thread on who to go for on porting, and you will get many opinions. good luck. Quote
trickedcarbine Posted August 16, 2014 Report Posted August 16, 2014 What type of riding and after seeing what is out there where do you want your bike to be in comparison? What level do you want it to go to? Quote
02Bansheeee Posted August 16, 2014 Author Report Posted August 16, 2014 We just do trail riding. He just suggested that I do a port job. & I examined my pistons more today under more lighting and saw a tad of scoring. & a tad on one of the cylinders. How do I measure the ring gap and piston gap? Quote
02Bansheeee Posted August 16, 2014 Author Report Posted August 16, 2014 I'm sure he just wants the bike to run on trails. Quote
02Bansheeee Posted August 19, 2014 Author Report Posted August 19, 2014 ( This is the RIGHT side ) it does need a hone, but could the engine be suffering from piston slap based on the way the lines are on the wall and piston? It's only on the parts of the wall where the piston could possibly touch it. Quote
sheerider11 Posted August 19, 2014 Report Posted August 19, 2014 Have you ever cleaned the air filter?? Or even run one? Quote
02Bansheeee Posted August 19, 2014 Author Report Posted August 19, 2014 this is the left side.. Nothing has been cleaned yet. Quote
02Bansheeee Posted August 19, 2014 Author Report Posted August 19, 2014 Yes I run a k&n without the lid, the dirt you see is from me touching the stuff outside of the bike and then me touching the components inside.. The cylinders didn't have dirt in them. Quote
02Bansheeee Posted August 20, 2014 Author Report Posted August 20, 2014 I just saw that the bottom of the right cinder has a chip on the bottom of the sleeve.bis this going to cause problems? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.