mattycotter Posted June 8, 2014 Report Share Posted June 8, 2014 hi guys i have a 2009 banshee and need to change the rear axel bearing they have ever been done before. So far i have taken the wheels hubs and the two nut near the sprocket off and tried to smash the axel out as i read on other post but it is not moving one bit is there any other way or am i doing it wrong Quote Link to comment Share on other sites More sharing options...
NYUK Posted June 8, 2014 Report Share Posted June 8, 2014 sometimes t takes a lil persuasion, penetrating oil, remove the carrier from the swingarm, stand it up in a corner, let oil soak in over night. then tap the carrier off it with a bfh. Quote Link to comment Share on other sites More sharing options...
mattycotter Posted June 8, 2014 Author Report Share Posted June 8, 2014 alright so there on hidden screw you just have to smash it out once the two nuts are off Quote Link to comment Share on other sites More sharing options...
NYUK Posted June 8, 2014 Report Share Posted June 8, 2014 no. Quote Link to comment Share on other sites More sharing options...
bansheefromhell Posted June 8, 2014 Report Share Posted June 8, 2014 Get a big brass hammer and beat the fucker out Quote Link to comment Share on other sites More sharing options...
special06shee Posted June 8, 2014 Report Share Posted June 8, 2014 I had to have mine pressed out. Fucker soaked it oil for 3days and still wouldnt budge. Quote Link to comment Share on other sites More sharing options...
Starwriter Posted June 8, 2014 Report Share Posted June 8, 2014 Take it to someone with a hydraulic press. Real easy and doesn't smash the threads on the end of the axle. Quote Link to comment Share on other sites More sharing options...
Buffalo-Banshee Posted June 8, 2014 Report Share Posted June 8, 2014 Heat it up! I just did this to a yfz 450 axel Quote Link to comment Share on other sites More sharing options...
mattycotter Posted June 13, 2014 Author Report Share Posted June 13, 2014 tried heating it up then smashing it out didn't work so took it to a shop to get pressed out and they couldn't even get it out any other ideas Quote Link to comment Share on other sites More sharing options...
toytech Posted June 13, 2014 Report Share Posted June 13, 2014 pop the seal out on the side the nut was on and stand on end and fill it with brake fluid and let it set for a couple of days and try again. Quote Link to comment Share on other sites More sharing options...
sheerider11 Posted June 13, 2014 Report Share Posted June 13, 2014 tried heating it up then smashing it out didn't work so took it to a shop to get pressed out and they couldn't even get it out any other ideasYour pressing towards the brake rotor right? A shop should have no issue Quote Link to comment Share on other sites More sharing options...
Starwriter Posted June 13, 2014 Report Share Posted June 13, 2014 If a 10 ton hydraulic press won't get it out, it's not ever coming out. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.