Need tie rods soon

[atcandbanshees]

Anybody know what length tierods work on -2+2 arms I want to order a set but everything is at the powder coater and I'm in a time crunch to get this bike together

[locogato11283]

Eh, I'm not sure on length, but when you figure it out, Ridiculous Fabrications can make you some.

[Starwriter]

Stock tie rod tubes are 10 7/8". I'll let you do the math from there.

[uman1030]

My Alba's are 13 3/16 for +2 wider. I think they differ slightly from brand to brand because you have some adjustment with the end.

[atcandbanshees]

I have plenty of stock ones I could measure I'm just unsure of the measurement cause they also go forward +2 on top of the -2 width. I figured somebody might see this that has the same placement a arms and could give me the length I need

[uman1030]

My bad, i missread, I see now you have -2 width +2 forward.

[locogato11283]

You might have to just mock them up and then have something made.

 

I like my tie rod ends to screw all the way into my tie rods. I don't like them hanging out so I order custom tie rods to suit my needs.

[Ridiculous Fabrications]

What aftermarket arms do you have? I'd be more than happy to make you a set. All I need is a measurement.

[J-Madd]

Lots of kart racing sites have them pretty cheap.

[Ridiculous Fabrications]

I'm gunna guess 9-9.5 would be a good length?

[atcandbanshees]

I have tyson a arms on this bike

[Ridiculous Fabrications]

Hmm. I no my buddy has Tyson J arms on his bike and they are narrowed. If u want take a measurement from steering shaft tie rod hole to spindle tie rod hole with the bars and wheel/ spindle straight and I'll make you a set. I have tie rod ends so I can subtract the takeoff.