Budweiserallday Posted December 6, 2013 Report Share Posted December 6, 2013 Going to rebuild my motor and I need to replace the crank seal . I can not get the bolt off the get the the water pump gear and primary drive gear . The crank is out of the bike , I kno I should have taken this bolt off befor I took the motor appart but I forgot. Ive tried an air gun at 100psi and It didnt work . Should I reassamble the bike and take it out then or what else should I try. Thanks for lookin Quote Link to comment Share on other sites More sharing options...
Finch Posted December 6, 2013 Report Share Posted December 6, 2013 stronger air gun 1 Quote Link to comment Share on other sites More sharing options...
Starwriter Posted December 6, 2013 Report Share Posted December 6, 2013 100PSI is your problem. Jeez, that's lame. I run my compressor at 180. Takes shit right off. Take your crank to someone that has a real compressor and have them buzz it off for you. Quote Link to comment Share on other sites More sharing options...
RagunCajun Posted December 6, 2013 Report Share Posted December 6, 2013 Go to a place that mounts tires. Use their impact gun. Give em 5 dollars ftw after. 1 Quote Link to comment Share on other sites More sharing options...
Zillaguy Posted December 6, 2013 Report Share Posted December 6, 2013 Impact gun Quote Link to comment Share on other sites More sharing options...
Bad one ton Posted December 6, 2013 Report Share Posted December 6, 2013 800ft/lbs. of breakaway torque at 90 psi. FTMFW! TON! Sent from my iPhone using Tapatalk 1 Quote Link to comment Share on other sites More sharing options...
Budweiserallday Posted December 6, 2013 Author Report Share Posted December 6, 2013 Thanks y'all I figured I needed a different gun . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.