Budweiserallday Posted December 6, 2013 Report Posted December 6, 2013 Going to rebuild my motor and I need to replace the crank seal . I can not get the bolt off the get the the water pump gear and primary drive gear . The crank is out of the bike , I kno I should have taken this bolt off befor I took the motor appart but I forgot. Ive tried an air gun at 100psi and It didnt work . Should I reassamble the bike and take it out then or what else should I try. Thanks for lookin Quote
Starwriter Posted December 6, 2013 Report Posted December 6, 2013 100PSI is your problem. Jeez, that's lame. I run my compressor at 180. Takes shit right off. Take your crank to someone that has a real compressor and have them buzz it off for you. Quote
RagunCajun Posted December 6, 2013 Report Posted December 6, 2013 Go to a place that mounts tires. Use their impact gun. Give em 5 dollars ftw after. 1 Quote
Bad one ton Posted December 6, 2013 Report Posted December 6, 2013 800ft/lbs. of breakaway torque at 90 psi. FTMFW! TON! Sent from my iPhone using Tapatalk 1 Quote
Budweiserallday Posted December 6, 2013 Author Report Posted December 6, 2013 Thanks y'all I figured I needed a different gun . Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.