375hp banshees Posted May 7, 2013 Report Posted May 7, 2013 is anybody running (34mm) lectrons on there dune ported stock cylinder shee ? w/ w/o power jets what needles I've got 34's w/ 3-1 needle & i'm at at sea level Quote
rubberneck Posted May 16, 2013 Report Posted May 16, 2013 i have 34 lectrons with PJs running sea level on a 4mil dune port motor. They are not HV I got them straight from packard and he put 5-2xl needles in them. I only ran them for 1 trip and they were pretty close but maybe needed a 5-3 needle. I had to run the needle out a bit to get the idle cleaned up then it seemed to be a little lean in the middle right before the PJs came on. I was going to order some to try however am making changes to the motor, so i will go with what i have and start the tuning process over and see where i land. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.