SAVAGE420 Posted February 22, 2013 Report Posted February 22, 2013 Lost all my common sense for a min. Quote
hoppedupandcutdown Posted February 23, 2013 Report Posted February 23, 2013 If you're just putting on a Pro-flow, why are you taking it apart there anyway? Quote
Larry's Shee Posted February 23, 2013 Report Posted February 23, 2013 If you're just putting on a Pro-flow, why are you taking it apart there anyway? Proably to replace the rustycrusty screws Quote
SpecialEd 05 Posted February 23, 2013 Report Posted February 23, 2013 While you got those screws out, split it at that joint and seal it up good with RTV silicone. That's a prime spot for air leaks. Also RTV the pro-flow in place too. Quote
joewest Posted February 23, 2013 Author Report Posted February 23, 2013 Had to take the air box to work to use there pencil grinder to cut the plastic tabs off. Quote
hoppedupandcutdown Posted February 23, 2013 Report Posted February 23, 2013 I remember having to grind on the lid, if you're gonna run it. Quote
joewest Posted February 23, 2013 Author Report Posted February 23, 2013 Yup i got it all done. Im only gonna use the lid when its real wet. Were heading out to go riding now Quote
Tech AS Posted February 23, 2013 Report Posted February 23, 2013 Sounds good. Definitely post pics of the box when your done. Quote
joewest Posted February 23, 2013 Author Report Posted February 23, 2013 I will tonight heading back from riding worked great! Just had to slow down when there was water. Runs better way more low end i think the jetting was off some. Its not poping or anything so i dont.think its too lean. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.