i have oko carb problems

[jimbo1986]

bowls are running dry!! how far should i adjust the floats ? and i know there is a mod ...how do u do this mod?

[gotta_goatsfast]

I drilled two 1/16" holes in the needle seat at the same elevation as the factory hole. Then, I removed one float from each carb and readjusted float height. They worked great for me.

[jimbo1986]

I drilled two 1/16" holes in the needle seat at the same elevation as the factory hole. Then, I removed one float from each carb and readjusted float height. They worked great for me.

thanks didnt know u could remove a float

[ionroller]

you dont need to remove a float.

 

Just drill the hole out a tiny bit bigger and set the floats very high and you will be fine.

[wfobasheeboy]

Here is a link to OKO mod for bowl running dry.

http://www.miniriders.com/tech-talk/26815-keihin-pwk-copy-carb-mods.html

[dave88]

I fought this problem for almost 2 years tried the inlet mod with no luck and finally switched to a dual pingle valve from cascade and never looked back

[camatv]

so weird i only see OKO chinese shit carbs doing this? never the pwks..

 

 

 

 

weird??

[jimbo1986]

thanks guys..... gonna try the mod if that doesnt work new carbs r getting ordered