Jetting

[smzj4]

1) What type of aftermarket exhaust do you have?toomey t5s

 

2) What type of airfilter do you have?k&n

 

3) Are you a)running a stock airbox with lid stock airbox with NO lid c) Stock airbox with vents d) no airbox at all?air box with lid but open to opinions

 

4) What is your elevation? (If you don't know, go here: http://www.topozone.com )1374

 

5) What size pilot jets are you using?25

 

6) What size main jets are you using?280

 

7) What temperature is your Banshee jetted for?not sure

 

8) Do you have a port job? no

 

9) What kind of carbs?mikuni vm26ss

 

10) What size carbs?26

 

11) Additional information? bored 80 over,vforce 3 reeds, stock cross over tube, not sure if this matters needle jet is 345, also where should i start with the clip on the jet needle, what digit?

Thanks

[smzj4]

anyone?

[bansheerage]

what are you asking???

[smzj4]

what are you asking???

 

well i just got vforce 3 reeds and toomey t5's and wanted to know where i should be with my jetting. i thought that was what the form was for????

[bansheerage]

I think your main could go up one possibly 2 sizes. maybee jump to a 27.5 pilot. put the clip in the middle position for now. then make adjustments as needed.

is it running or was it running?

[smzj4]

it was running but had fmf fattys on but not jetted correctly because when i hit the powerband in 4th gear it would just fall flat on its face.

[bansheerage]

bump that main up

[Husemoller]

bump that main up

 

Ya man I have 320s in my carbs right now and all I have is t5s and kn filter. but it is like 20 degrees out

i was a little surprised that it ran pretty good at that jet. I thought I would be rich but she seems to run pretty good

[Larry's Shee]

I think what the plan is that when you get it sorted out THEN you post it in that thread at the top ,so if I have a simular setup I look and say ok IF I start with a xxx jet I should have a good starting point. Also might want to try 27.5 pilot.