Override jumping out of gea!

[Banshee dav]

I have a full 1-6 override that will jump out of gear when under a load. I changed the shift forks.

And it still does it. It will shift fine if you are not putting a load on it. What could it be?

it just started doing this. It looks fine. Nothing is broke or chipped. It is pissing me off bad!!!

[RagunCajun]

Do you have a modded shift star and/or shift kit(like shift pro)?

[VictorK]

My 250R was doing that once the shift drum was loose

[Banshee dav]

Do you have a modded shift star and/or shift kit(like shift pro)?

No i do not have a modded shift star.

[sleeper06]

Rounded dogs and possibly back cuts on sliders are worn,they might visually seem ok.I know wcr reconditions trannies and if you can get a hold of him he prob has an answer for you

[AKheathen]

x2 on the dogs. if you had to replace the fork(s), then 90% sure the dogs are going to be chewed/rounded, which will bend the fork again. i had to fix that exact problem/symptom last fall. i have also seen a peak in the drum channel worn down, too, which probably started the dogs/fork damage in the first place. just check everything over real good for slop, misalignment, and wear.

[Banshee dav]

I sent my trans back to Joey. He is going to repair the ramps and the dogs were rounded on third gear.