shakenbake1285 Posted May 26, 2010 Report Share Posted May 26, 2010 What is the best or fastest way to get the rear bearings out Quote Link to comment Share on other sites More sharing options...
twizted269 Posted May 26, 2010 Report Share Posted May 26, 2010 hammer and bar from the inside out. there is a long bushing in there that should move out of the way with a little work. Quote Link to comment Share on other sites More sharing options...
SAVAGE420 Posted May 26, 2010 Report Share Posted May 26, 2010 Yup, as said, BFH and punch. 2 min job. Quote Link to comment Share on other sites More sharing options...
lilitalypimp19 Posted May 26, 2010 Report Share Posted May 26, 2010 Used a press at worked and they walked right out with no problems Quote Link to comment Share on other sites More sharing options...
SD1026 Posted May 26, 2010 Report Share Posted May 26, 2010 a berring punch or a beat up flathead. Quote Link to comment Share on other sites More sharing options...
J-Madd Posted May 26, 2010 Report Share Posted May 26, 2010 Yup, as said, BFH and punch. 2 min job. The couple of sets that I have changed were hell. Took a BFH, propane torch, and a punch. Lot longer than 2 mins!! Quote Link to comment Share on other sites More sharing options...
SAVAGE420 Posted May 26, 2010 Report Share Posted May 26, 2010 The couple of sets that I have changed were hell. Took a BFH, propane torch, and a punch. Lot longer than 2 mins!! Ok ok. 5 mins Quote Link to comment Share on other sites More sharing options...
Koolguyson Posted May 27, 2010 Report Share Posted May 27, 2010 Don't use a press to put the new ones in. It can walk sideways and ruin the bearing/carrier. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.