HORSEFLY Posted April 28, 2010 Report Share Posted April 28, 2010 I have oil and water coming out of the 1/4'' hose that comes out under to the water pump . I've changed the water pump impeller , bearing and the seal that the impeller shaft goes thru .What would be causing this? Quote Link to comment Share on other sites More sharing options...
Phelps Posted April 28, 2010 Report Share Posted April 28, 2010 your crankcase is full of coolant i would bet. pull the drain bolt on the bottom of the engine, but have a large pan ready lol are you sure you remembered to put the new seal in, or the O-ring that goes on the tube between the clutch cover and case? Quote Link to comment Share on other sites More sharing options...
White97Banshee Posted April 28, 2010 Report Share Posted April 28, 2010 If it were base or head gaskets it would be in your cylinders but it sounds like it could be leaking through whatever was used to bond the cases together. Might be time to split em, scrape the old stuff and put new sealer and slap em back together. Just make sure you let it cure for at least 24 hours so this doesn't happen again. Quote Link to comment Share on other sites More sharing options...
firebanshee Posted April 28, 2010 Report Share Posted April 28, 2010 You could have cut the o ring on the pipe that goes in your side cover. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.