swing arm bushing

[jonnybanshee]

ok so i had a hell of a time getting my swingarm bolt and sleeve out... and i was wondering if anyone has drilled and installed a grease zerk on the swingarm in the middle of the pivot shaft? i dont have my motor together and not sure of where i could access it freely with out the shock linkage or motor being in the way... any ideas or pics would greatly help guys! thanx

[twizted269]

as you have notice im sure is the bearings are on the outside so anywhere in between it will fit is fine. good luck.

[FREAKSHOW]

ok so i had a hell of a time getting my swingarm bolt and sleeve out... and i was wondering if anyone has drilled and installed a grease zerk on the swingarm in the middle of the pivot shaft? i dont have my motor together and not sure of where i could access it freely with out the shock linkage or motor being in the way... any ideas or pics would greatly help guys! thanx

 

 

The swing arm bolt is hollow, so if it was me I would cap off 1 end with a pipe plug like 1/8 in. Then on the other end put a zerk fitting (thats a grease fitting). Then i would drill a small hole in bolt to allow grease out of the center of it up to bearings, now your concern of how to get to it is fixed also.