Jump to content

Recommended Posts

Posted

i have a 04 banshee and i just got down with it and it was fine for about an hour. then the bike didn't even want to rev up anymore it just pops out the pipes and has no power at all but starts right up.

 

 

 

i am 570ft above sea level

t5's

vf3 reeds

2 into 1 air filter

cool heads 21cc domes

300 mains

 

 

 

i don't know if it was my jetting because it was running fine.i did notice that i have a little cut in the boot below the boost bottle and i also did melt a few wires but nothing to bad

 

PLEASE HELP

Posted
i have a 04 banshee and i just got down with it and it was fine for about an hour. then the bike didn't even want to rev up anymore it just pops out the pipes and has no power at all but starts right up.

 

 

 

i am 570ft above sea level

t5's

vf3 reeds

2 into 1 air filter

cool heads 21cc domes

300 mains

 

 

 

i don't know if it was my jetting because it was running fine.i did notice that i have a little cut in the boot below the boost bottle and i also did melt a few wires but nothing to bad

 

PLEASE HELP

 

 

Throw the bottle away. Get your self some new carb boots and a stock crossover tube. You are just going to melt your pistons trying to run it with airleaks.

Posted
YES ALMOST LIKE THE CHOKE IS ON BUT IT DONT REV UP AT ALL

Check the reeds....

 

When I had my blaster it did the same thing you are talkin about.

Pulled the carb off and ill be damned if it wasnt a reed that shattered.

 

 

Dan

Posted
Check the reeds....

 

When I had my blaster it did the same thing you are talkin about.

Pulled the carb off and ill be damned if it wasnt a reed that shattered.

 

 

Dan

 

EVEN ON BRAND NEW REEDS

Posted
I would still check them....

Just pull the carbs out of the boots and look in at the reeds.

 

Dan

 

I HAVE NEW T5'S AND I EVEN NOTICE THAT THE SIDE WITH THE CUT IN THE BOOT THE PIPE IS BURNED A LOT MORE AND FARTHER UP THEN THE OTHER SIDE

Posted
Im concerned with the melted wires how bad and which ones,certain wires will cause similar problems ,check the boot an air leak is no joke

 

yea i have a really good feeling that it is the wires because when it started doing that is when i noticed the wires and they were freshly melted

Posted
yea i have a really good feeling that it is the wires because when it started doing that is when i noticed the wires and they were freshly melted

 

 

BUT DO YOU THINK THE WIRES WILL CAUSE ONE CYLINDER TO ACT LIKE THAT

Posted

just changed my boot and did my wires over and is still acting the same way.Like i said it was running fine for about an hour and then just started acting like this. It will start up with no problem but when i try to rev it up it just really wont and pops to

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...